Summit PRO24G - Manual (Page 16)

If not already present, install a gas shut-
off valve in an easily accessible location.
Make sure all users know where and
how to shut off the gas supply to the
range.
NOTE: The installer should inform the
consumer of the location of the gas
shut-off valve.
Flexible Connector Method (see fig. 4)
1. Install a male 1/2" flare adaptor at the
1/2" NPT internal thread of the range
inlet. Use a backup wrench on the
elbow fitting to avoid damage.
2. Install a male 1/2" or 3/4" flare union
adaptor on the NPT internal thread of
the manual shut-off valve.
3. Connect the flexible metal appliance
connector.
4. Make sure circuit breaker is off and
then plug range cord into electrical
outlet.
5. Push range back into position
insuring that range leg slides under
the anti-tip bracket. The range will sit
3/4" away from the wall when
properly installed.
NOTE: Be careful not to crimp the
flexible connector!
6. Carefully tip range forward to insure
that anti-tip bracket engages and
prevents tip-over.
Rigid Pipe Method (see fig. 4)
The configuration of the rigid pipe
connection will vary depending on the
location of the gas pipe stub. Refer to
fig. 4 for details.
1. Make sure circuit breaker is off and
then plug range cord into electrical
outlet.
2. Push range back into position
insuring that range leg slides under
the anti-tip bracket. The range will sit
3/4" away from the wall when
properly installed.
3. Carefully tip range forward to insure
that anti-tip bracket engages and
prevents tip-over.
4. Connect pipe to range at union.
Access the connection through the
access panel behind the warming
drawer.
NOTE: Be careful not to apply
pressure to warming drawer element
during rigid pipe installation.
Fig. 4
15