Unisteer 8012000-01 Ford Fairlane & Ranchero Rack 1966-1967 - Manual (Page 7)

Page 7 656800
10. Install the supplied pinion joint onto the pinion and start the 6 mm pinch bolt. Install the supplied
column shaft into the column and slide it down till the end of the shaft just pokes through the column
bearing. Install the intermediate shaft into the pinion joint and start the pinch bolt. Next have someone
hold the column joint in place over the top of the spline on the intermediate shaft making sure the u-
joints are out of phase 90 degrees. Next, aim the top part of the joint toward the column shaft and
have someone slide the shaft down through the joint and engage it with the pinch bolt.
11. Next tighten up the pinch bolts to 40 ft lbs. making sure nothing is binding or rubbing when turning.
Pay close attention to the driver side mounting bracket to make sure the joint or shaft is not rubbing
the bracket or the bolt.
12. Next we need to install the pump. The bracket and pump were shipped assembled you need to
remove your old pump and bracket assembly. Install the main mount bracket and pump in place using
the 2 standoffs and longer 5/16” bolts. You must remove the 2 water pump/timing cover bolts and
install the bracket and standoffs in their place with the longer bolts.
90° out of phase
2 water pump/timing cover bolts