Unisteer 8012000-01 Ford Fairlane & Ranchero Rack 1966-1967 User Manual
Page 8
Page 8
656800
13. Then install the pressure and return line. Note the pressure line has the 1 female end on each end
and is the smaller diameter. That line runs to the lower port on the rack and the top port of the power
steering pump. The return hose, larger diameter, goes to the upper port of the rack and the slip on
end goes over the reservoir plastic nipple with a hose clamp. Tighten all lines to 15 ft lbs. Make sure
your line routing is good. Do not route lines so they kink or come in contact with hot or sharp
surfaces.
14. Last, install your steering wheel, nut, and horn pad.
15. Measure the length of the new belt and purchase from local shop. Install and tighten belt.
16. Top off the reservoir with power steering fluid. Start the motor and let idle to purge air from system.
Do not turn wheel. Top off fluid again right away. Restart vehicle and turn wheel right to left without
going to stops to purge air. Verify full reservoir and verify no leaks.
WARNING: IF PRESSURE AND RETURN LINES ARE BACKWARDS SEALS WILL INSTANTLY
BLOW OUT OF RACK.
17. You will now need to take the vehicle to a qualified shop for an alignment. NOTE: Toe adjustment is
made by turning the inner tie rod ends with outer ends installed and jam nuts loose. Once toe is
adjusted tight the outer tie rod jam nuts.