Unisteer 8010540-02 Camaro 1967-69/Nova 1968-74 Power Rack & Pinion - Manual (Page 4)

pg. 4 655410
Installation
1) Remove the driver side rear lower control arm bolt. To do this use one of the new bolts
that is provided, and drive the old bolt out with the new bolt. Using the other new bolt,
drive the bolt you just installed out so that the threaded end of the new bolt is facing the
back of the car. You may need to draw the bolt through by tightening the nut, if so
remove the nut after the bolt has been completely drawn through. Install one of the steel
spacer (stand off) provided.
2) Prepare to remove the passenger side control arm bolt. Shift the jack to the passenger
side.
3) After removing the nut, drive the old bolt out using the old driver’s side bolt. Take the
remaining new bolt and drive out the old bolt you just installed back out so that the
treaded end is facing the back of the car. Drive the bolt through, just enough for the stand
off and the rack bracket to hang on.
4) Hang the new rack and pinion on the two 2 control arm bolts (see above). Install the new
nuts and torque to 85 ft/lbs.