Unisteer 8001050-02 Ford Faicon/Comet 1960-65 - Manual (Page 5)

pg. 5
655600
10. From under dash, remove six sheet metal bolts that retain to column support place to firewall
and floor. Remove plate and discard.
Installation:
1. Your stock column must be measured from the bottom and one inch cut off.
Note: This must be done in a band saw or something that makes an accurate square cut.
2. Install steering column bearing in bottom side of column tube. Tap bearing into place against
lip of bearing until it stops against column tube.
3. Install new column support plate on firewall using new attaching hardware.
Note: If your car is equipped with a manual transmission it will be necessary to
remove rubber plug from plate to install your clutch pedal linkage rod.