Unisteer 8001050-02 Ford Faicon/Comet 1960-65 - Manual (Page 8)

pg. 8
655600
7. Make sure your pinion is still centered at rack and adjust tie rods as close as you can to point
wheels straightforward. Tighten jam nuts and outer tie rod ends.
8. Install front wheels and torque to spec.
9. Lower vehicle to ground and look to see if tires are reasonably straight.
10. From inside vehicle, install steering wheel so spoke is straight and torque nut to 35 ft. lbs.
11. Tighten column support bolts to dash and torque to 35 ft. lbs.
12. Reconnect electrical connector or connections.
13. Reinstall transmission clutch linkage if equipped at pedal.
14. Tighten column clamp onto tabs of column plate.
15. Vehicle will now require an alignment by a professional to set toe adjustment.
Alignment Specs:
Toe In: 0 - 0.125
Camber: O.E. Specs
Caster: O.E. Specs
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/13/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.