Unisteer 8052760 Improved Electra-Steer Ididit Column - Manual (Page 2)

Page 2 657240
BEFORE YOU START PLEASE READ!
Designing steering systems requires an understanding of steering function and design. If you are
inexperienced it is recommended that you seek professional help before beginning a steering
project.

The Unit is intended for normal highway use in vehicles not exceeding 4500 lbs (2000 kg).

The column MUST be firmly anchored. All Torque required to steer the vehicle will be transferred
through the column mounts.

The unit CANNOT be mounted near a heat source, exposed to excessive moisture/water, or
submerged under water.

All Steering Shafts, Joints, U-Joints, and Connectors must be designed to withstand the full load of
the steering system to which the electric motor is being installed.

The Wiring, Module, and Motor must not be tampered with. Any modification to the Module or Motor
will void any existing or implied warranties, if so offered.

FAILURE TO ADHERE TO THE ABOVE WARNINGS MAY RESULT IN SERIOUS INJURY OR
DEATH. Maval Manufacturing and Unisteer Performance IS NOT RESPONSIBLE FOR
IMPROPERLY INSTALLED ELECTRIC STEERING SYSTEMS.
Installation Instructions for
Universal 2” Column Electric Steering Kit
1. First cut out each template from the last two pages of these instructions.
2. The two templates are different. The one has the three holes in the center and the other has the three
holes offset to one side. Use the offset one labeled 206230 for the top half, the upper bell side, of the
column. The holes will go closest to the top of the column as pictured. Tape the strip with the slit in
the direction where you want the electric motor to point. We aligned the slit with the top of the column
so the motor will point straight up.