Unisteer 8001640-01 Late 67-70 Manual Mustang & Cougar - Manual (Page 6)

pg. 6
655860
12. Install supplied brass washer and u-joint. With both of these pieces installed, make sure there is not a
gap between the lip of the bushing and the end of the steering column.
If a gap exists, go to the 1970 Mustang column modification instructions.
13. Reinstall the steering column back into the car. Install the supplied shaft into the U-joint on column.
Connect the other end to the U-joint on the rack and pinion.
14. When installing the shaft, be sure to keep the U-joint phasing 90 degrees apart. Torque all pinch bolts
to 40 ft. lbs.
15. Verify that your rack is centered and set your toe adjustment by eye trying to keep the front wheels
straight. Once you have this done install your steering wheel in place and tighten to 30 ft.lbs. Reinstall
the horn pad and take the car to a professional for an alignment. Enjoy the drive.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/20/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, with permission in writing from Maval Manufacturing Corporation.