Unisteer 8001640-01 Late 67-70 Manual Mustang & Cougar - Manual (Page 9)

pg. 9
655860
12. You now need to install the provided aluminum bushing over the shaft.
13. Next, install the solid piece of steel stock into the steering shaft. Make it flush with the steering shaft.
14. Next install the u-joint over the steering shaft. Using the supplied drill bit and the pilot hole in the u-
joint drill through the pilot hole and clear through the other side of the u-joint.
Note: Keep your drill as straight as possible. We recommend the use of a drill press.
15. Next install the roll pin provided in the kit. Tap it into place and then install the smaller pin inside of it.
This will lock it in place.
16. You can now reinstall your steering column assembly.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/20/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, with permission in writing from Maval Manufacturing Corporation.