Unisteer 8001640-01 Late 67-70 Manual Mustang & Cougar - Manual (Page 7)

pg. 7
655860
WARNING, for 1970 model year ONLY
1970 Mustang Column Modification
1. Remove 4 bolts at firewall plate.
2. Remove lower plastic trim panel to access dash hardware.
3. Remove the 3 nuts that retain the steering column to the dash.
4. Disconnect the main wire harness off the ignition switch and the turn signal switch.
5. Make sure the steering box is disconnected and remove the steering column from the vehicle.
6. Once the column is out of the car, do the following. In a band saw or using a sawsall cut the
steering shaft off as close to the weld of the rag joint as you can.