Unisteer 8012350-01 Ford Galaxie 500 Rack & Pinion Kit 1965-67 - Manual (Page 12)

Page 12 657340
20. The power steering pump is an easy install and comes with the pump brackets attached to it. Bolt on
the pump using the provided hardware with the longer spacer on the lower bolt and the shorter
spacer up top in-between the two mounting brackets. Measure the belt length and install belt. Tighten
the hardware.
21. Now install the power steering hoses. Route hoses from the pump looped over and down to the front
of the rack. Connect the hoses to the pump. They can only attach to the pump one way. Make sure
the hoses are away from the headers. The smaller diameter hose is the pressure line and mounts to
the lower larger port of the rack. The large diameter hose is the return line and mounts to the upper
smaller port of the rack. Use the provided hydraulic stop leak on each side of all crush washers and
tighten each banjo fitting. Once tight with the stop leak do not break loose. A leak free seal may not
be created a second time with the crush washers on the banjo fittings.
WARNING: Incorrect Installation of the Pressure Port Will Damage Gear & Void All Warranties.
22. When your lines are connected and all hardware is tight you may top off the fluid in the reservoir and
start the car. Use only power steering fluid. DO NOT USE ATF.
23. Let the car idle and turn the wheels back and fourth slowly to remove air from the system. Start with
small turns and gradually make your way out to full lock to lock turns.
24. Shut the car off and make sure you have no leaks and the level is full.