Unisteer 8012350-01 Ford Galaxie 500 Rack & Pinion Kit 1965-67 User Manual
Page 8
Page 8
657340
11. Take the end of the Rag Joint Shaft that you cut, and deburr the inside of the tube. Next, insert the
steel slug provided in the kit into the Rag Joint Shaft. Tap the slug into position so it is flush with the
stock shaft.
12. Next, install the Rag Joint Shaft back into the column. Slide the provided bearing over the shaft and
tap into the column housing until seated on shoulder. Install the supplied column tube bearing by
tapping it in with a hammer.
NOTE: You have to align the stock shaft and make sure the bearing slides easily over the shaft. Damage
to the needle bearings and bindings of the shaft will occur if note done properly.
13. Install the brass washer and then the U-Joint with the set screws over the end of the shaft. Make the
shaft flush with the inside yolk of the U-Joint, and tighten the set screw. Next, with the drill bit
provided, drill into the thru hole on the joint and through the shaft and out the other side of the joint.
Install the provided ¼” Roll Pin and install the 1/8” Roll Pin inside the ¼” Pin.