UVP iBox Anesthesia System - Manual (Page 6)

iBox Anesthesia System 6
Figure 1: Attach Regulator to
Oxygen Tank
Setup of iBox Anesthesia System
The following is a schematic diagram of the five-port iBox Scientia and iBox Spectra anesthesia
system. The specific components (letters) of this schematic will be referenced parenthetically
throughout this manual.
Note: The only difference between this schematic and the anesthesia system for the iBox Explorer is
the replacement of a single-port breathing device/manifold in place of the five-port component
shown below.
Connecting Outside the Darkroom
1. Attach the Regulator to the Oxygen Tank (Figure 1):
Be sure that the oxygen tank is secured and stable
before attaching the regulator.

To mount the oxygen regulator (B) to the oxygen
tank, attach regulator fitting to the oxygen tank
output and tighten the black handle wheel.