UVP GelCam 310 Camera - Manual (Page 5)

GelCam 310 5
6. Plug in the serial cable from the motorized lens
to the lens control box.
7. Plug the 90 degree cable into the top of the
camera. Leave the other end unplugged until
you are ready to install the Visionworks disk.
8. Connect the cable to the PC connection port on
the lens control box. Leave the other end
unplugged until ready to install the USB Drivers
disk.
9. Connect the power supply to the lens control
box and into the power outlet.
Software Installation (for GelDoc-It)
The lens is controlled through VisionWorks®LS software.
Note: Make sure the system has at least a VisionWorksLS Version 7 before continuing with the installation.
Install the Lens Control Driver
1. Turn the switch on the Lens Control Box to the “Off” position.
2. Connect the USB cable to the PC (or the GelDoc-It TS) from the Lens Control Box.
3. Turn the Lens Control Box power switch to “On”.
4. A Found New Hardware wizard will appear. Select the yes option when prompted to allow the wizard to
connect to Windows. Update and click Next.
5. Once the driver has finished installing, click Finish.
Install the Camera Driver
1. Install VisionWorks®LS software.
2. Plug in the 90 degree cable from the camera into the USB port (or the GelDoc-It TS).
3. The computer should display Found New Hardware. Click Yes, Next, Install from a list, Next, Don’t
search, Next, double click on Show all Devices, click Have disk, and then the browse button.
4. Browse to the C:\Windows \system32\drivers folder and select the STUSB.inf file.
5. Select Open and then OK to install the camera.
6. Select Finish.
Note: the installation may cause a warning message saying that the drivers are “not verified by
Microsoft”. Select “Continue Anyway” and the drivers will be installed correctly.
PC Connection on the
Lens Control Box
Power Connection