UVP GelCam 310 Camera - Manual (Page 7)

GelCam 310 7
Bracket and base securing camera
Software Installation (for BioSpectrum)
The lens is controlled through VisionWorks®LS software.
Note: Make sure the system has at least a VisionWorksLS Version 7 before continuing with the installation.
Install the Lens Control Driver
1. Unplug the Motorized Lens at the top of the BioSpectrum then plug it back in.
2. A Found New Hardware wizard will appear. Select the yes option when prompted to allow the wizard to
connect to Windows. Update and click Next.
3. Once the driver has finished installing, click Finish.
Install the Camera Driver
1. Install VisionWorks®LS software.
2. Plug in the 90 degree cable from the camera into the USB port on the computer.
3. The computer should display Found New Hardware. Click Yes, Next, Install from a list, Next, Don’t search,
Next, double click on Show all Devices, click Have disk, and then the browse button.
4. Browse to the C:\Windows \system32\drivers folder and select the STUSB.inf file.
5. Select Open and then OK to install the camera.
6. Select Finish.
Note: the installation may cause a warning message saying that the drivers are “not verified by
Microsoft”. Select “Continue Anyway” and the drivers will be installed correctly.
Knob for attaching
camera to bracket