UVP GelCam 310 Camera - Manual (Page 6)

GelCam 310 6
BioSpectrum with Motorized Lens
This configuration comes with:

GelCam 310 Camera

Motorized lens

Lens control box

+2 diopter

Bracket

Base (typically shipped on system)

USB Cable (for connection from camera to PC)
Hardware Installation
Slide the camera and lens assembly into the camera
base.
Plug in the serial cable from the motorized lens to the
darkroom.
1. Plug the 90 degree cable into the top of the
camera. Leave the other end unplugged until
ready to install the Visionworks disk.
2. Place the bracket on the mounting base aligning
the holes on the base. Using the four thumb
screws provided, secure the bracket to the
base.
3. Insert and tighten the knob/washer to secure
the camera to the bracket. Be sure to position
the knob in the central hole in the camera.
USB Connection
for camera
Serial
connection for
motorized lens