UVP BioChemi 500 Camera - Manual (Page 3)

Chemi 410 and BioChemi 500 Cameras 3
Set up the darkroom and unplug all components from the power outlet. Refer to the BioSpectrum Imaging
System Manual for more information.
The base mount (3) is preassembled and attached to the BioSpectrum darkroom at the UVP factory. If not,
secure the base mount to the darkroom with the long screws provided.
Attach the camera bracket (4) to the base with the thumb nuts (8).
The camera and lens (2) should be preassembled at the factory. Place the camera/lens assembly over the base
mount and secure the camera to the bracket (4) with the knob (5).
Note: When positioning the BioChemi 500 camera, make sure that the cables are extending to the left of the
camera when viewed from the front of the BioSpectrum darkroom. If this is not the case your image may
display an incorrect orientation.
Connect the camera power supply to the camera well at the top of the darkroom. If upgrading the system, plug
the power supply into the wall outlet.
Once the software is installed, connect the camera USB cable to the camera and then into an available port on
the computer.
1. Camera USB cable
2. Camera and lens
3. Base mount
4. Bracket
5. Knob
6. Camera cover
7. Lens control box
8. Thumb Nuts
1
2
3
4
5
6
7
8
5