UVP BioChemi 500 Camera - Manual (Page 5)

Chemi 410 and BioChemi 500 Cameras 5
Set up the darkroom and unplug all components from the power outlet. Refer to the BioSpectrum Imaging
System Manual for more information.
The base mount (3) is preassembled on top of the BioSpectrum at the UVP factory. If not, secure the base mount
to the darkroom with the long screws (10).
Attach the camera bracket (4) to the base with the thumb nuts (10).
The camera (2) should be preassembled with the motorized zoom lens (7), step-up ring (6) and the diopter (9)
and magnifier (8). Place the camera/lens assembly over the base mount and secure the camera to the bracket (4)
with the knob (5).
Connect the camera power supply from the BioSpectrum’s camera well to the camera. Locate the cable
extending from the top of BioSpectrum darkroom. If upgrading the system, plug the power supply into the wall
outlet.
Install the VisionWorksLS software to run the camera if not already installed. Refer to the PDF VisionWorksLS
software manual on the Support CD or use the Help Files embedded in the software for more information.
Once the software is installed, connect the camera ’s USB cable to the camera and then into an available port on
the computer.
Connect the cable from the motorized zoom lens to the back of the BioSpectrum darkroom.
Refer to the BioSpectrum Imaging System manual for additional system assembly and user instructions.
1. Camera USB cable
2. Chemi 410 Camera
3. Base mount
4. Bracket
5. Knob
6. Step-up ring
7. Auto zoom lens
8. Magnifier
9. Diopter
10. Screws and thumb nuts
11. Power cord
12. Camera power supply
1
2
3
4
5
6
7
8
9
10
11
12