UVP OptiChemi 600 Camera - Manual (Page 4)

OptiChemi Camera 4
Installation
The camera kit assemblies attach the OptiChemi 600 to the BioSpectrum Imaging System and ChemiDoc-It Imager. The
camera is controlled by VisionWorksLS software. Refer to the BioSpectrum or ChemiDoc-It manual for additional system
information and the VisionWorksLS Software Manual or Help Files for software information.
OptiChemi 600 Camera Kit with Motorized Fixed Lens
Installing on the BioSpectrum Imaging System
The photograph shows parts required for assembly of the camera kit with the automated/motorized fixed lens onto the
BioSpectrum Imaging System and ChemiDoc-It Imager.
•
Set up the darkroom and unplug all components from the power outlet. Refer to the BioSpectrum Imaging
System Manual and ChemiDoc-It Imager Manual for more information.
•
The Base Mount (1) is preassembled and attached to the BioSpectrum and ChemiDoc-It at the UVP factory. If
not, secure the base mount to the darkroom with the long screws (not shown).
•
Attach the Camera Bracket (2) to the base with the Thumb Nuts (3).
•
The OptiChemi 600 (4) should be attached to the Motorized Fixed Lens Controller (5) and Lens (6). Place the
camera/lens assembly over the base mount at the top of the darkroom and secure the camera to the Camera
Bracket (2) with the Knob (7).
•
Connect the 15-pin camera Power Supply cord (8) to the camera well at the top of the darkroom.
Note: Although the picture shows a rectangular power supply, a power cord, and a pinned power connector, only
connect the pinned power connector coming from the darkroom to the camera. If upgrading the BioSpectrum or
1
2
3
9
6
4
7
5
8
10
1. Base Mount
2. Camera Bracket
3. Thumb Nuts
4. OptiChemi 600
5. Motorized Fixed Lens
Controller
6. Lens (f/1.2 shown)
7. Knob
8. Power Supply
9. Ethernet Adapter and
Ethernet Cable
10. Camera Cover