UVP OptiChemi 600 Camera - Manual (Page 5)

OptiChemi Camera 5
ChemiDoc-It from another camera type to the OptiChemi 600 camera, all power supply parts will be visible. In
this case, the power supply cord must be plugged into a wall outlet.
•
Insert Ethernet Cable (9) into the camera and other end into the Ethernet Adapter.
•
Once the software is installed, connect the USB cable extending from the Ethernet Adapter into an available port
on the computer.
•
Install the VisionWorksLS software to run the
camera if not already installed. Refer to the PDF
VisionWorksLS software manual on the Support
CD or use the Help Files embedded in the
software for more information.
•
To connect the motorized lens (showing the
motorized fixed lens in the photograph):
•
Connect the Power Cable to the Power
Supply
•
Connect the Power Cable to an electrical
outlet
•
Connect the USB cable to an available port
on the computer.
Configure the Settings
•
Connect the camera to a dedicated Ethernet port
on the computer via the Ethernet adapter cable.
•
Plug in the camera power supply (extending from
the darkroom) into the 15-pin connector on
camera. If upgrading the system, plug the power
supply into the wall outlet.
•
Go to the Windows Control Panel > Network
Connections
•
Select the connection used for the camera, right
click and select Properties
UVP Lens Controller
(pictured without
camera and lens)
Power Cable
Control Box
Power Supply
USB cable