UVP SI-950 Ultraviolet Incubator - Manual (Page 5)

UV Incubator Page 4
Care and Cleaning
The units are built to provide trouble-free operation.
NOTE: The door is made of a polycarbonate plastic material and is subject to scuffing and
scratches if improperly cleaned.
To ensure correct operation:
•
Wipe excess water from inside the unit and outside the unit with an absorbent soft cloth or
sponge.
•
Use mild soap and water with a soft cloth or sponge to clean the exterior of the unit.
•
Use a mild detergent on the interior surfaces.
•
Warning: Unplug the UV incubator before cleaning around the UV bulb contacts.
•
Clean the door with a mild detergent; never use organic based compounds or cleansers
containing alcohol or ammonia.
•
Do not use abrasive pads or cleansers.
•
A plastic cleaner solution is recommended to clean the door. Such cleaner is available
from local plastic supply distributors.
Replacement Parts and Replacement Instructions
Replacement parts are listed below for the SI-950 UV Incubator:
•
Key, replacement 53-0178-03
•
Tube, 8-watt, 254nm shortwave germicidal 34-0007-01
•
Tray, stainless steel ventilated 10-0341-08
•
Spectacles, UV blocking (UVC-303) 98-0002-01
•
Goggles, UV blocking (UVC-503) 98-0002-02
•
Face Shield, UV blocking (UVC-803) 98-0002-04
Replacing the UV Shortwave Bulb
1. Turn the unit power off and unplug the unit from the power outlet.
2. Open the incubator door and locate the bulb. Carefully rotate the tube and slide the bulb
out of the socket.
3. Using two hands, carefully hold the bulb and fit the bulb end into the socket. Replace with
a new tube by sliding the tube into the socket and rotating into place.