UVP Ultraviolet PCR - Manual (Page 8)

Ultraviolet PCR Cabinets and Workstations Page 8
Door Assembly
1. Slide the upper panel of the door assembly into slotted area in the top assembly. Holding the door
in position, insert the thumb screws (Qty. 3) inside the top assembly.
2. Secure the upper panel of the door assembly to the left and right side panels with the two side
brackets.
3. Create the door assembly by connecting the upper and lower door panels using the two hinges and
8 nuts.
4. A magnet is attached to the bottom right bracket on the door. The purpose of the magnet is to shut
off the overhead UV light when the door is open.
Note: Some systems may have a single large bracket running along the width of the entire lower
door, rather than the two small brackets shown below.
WARNING: The PCR is for laboratory use and cannot be connected to a public power supply.
When the PCR is assembled, plug the power cord into the back of the unit and then into a wall
outlet in the laboratory.
Operating the PCR Systems
The Ultraviolet PCR Systems feature:
•
Overhead UV for decontamination of the chamber or PCR equipment
•
UV safety switch and keylock for preventing exposure to UV
•
Antimicrobial coated stainless steel and aluminum for reducing bacterial growth
•
Easy-access door
•
Overhead white light
•
Shelves for placement of tools
•
Built-in power outlets built into the chamber interior
Thumb Knobs
Door Assembly
Side Brackets
Magnet
Top Assembly
Door Hinges