Vicor VI Chip PRM Evaluation Board - Manual (Page 17)

UG:013 vicorpower.com Applications Engineering: 800 927.9474 Page 17
Figure 7.
PRM evaluation board
connection to
VTM evaluation board
Recommended Test Equipment
The following is a list of recommended test equipment.
1.
DC power supply: 0 - 80 V, 600 W minimum
2. Load: Rated appropriately based on output voltage, current and power
requirements.
3. Digital multi-meters (DMMs)
4. Oscilloscope + probes
5. Function generator (for external enable/disable and trim control)
6. Auxiliary bench voltage supply (for external trim and AL control)
7. Network analyzer (Remote Sense Operation)
8. Interconnect wires, cables and fastening hardware.
9. Calibrated input and output shunts, appropriately rated (for efficiency
measurements)
10. Trim pot screwdriver
11. Fan
12. Datasheets of requisite PRM ® and VTM ® device used.
13. Safety glasses
14. Thin bladed tool for wire extraction from paralleling connectors
(AVX part number: 06-9276-7001-01-000)
Push pin heat sink installation
Each PRM ® and VTM ® evaluation board comes with its own heat sink and push pins for
installation. Before testing, it is highly recommended that heat sinks be installed in the
appropriate location for each board. When installing the push pin heat sink, use caution
not to exceed the maximum compressive on the device listed in the data sheet.