Vicor VI Chip PRM Evaluation Board - Manual (Page 22)

UG:013 vicorpower.com Applications Engineering: 800 927.9474 Page 22
The following table describes the switch configuration.
In this configuration, PRM operates in Remote Sense. PRM module output voltage is
sensed through divider formed by R29 and R31. U11B is configured as buffer as shown
in figure 13 and provides the sense voltage to error amplifier U11A. R33, R41 and R27
are left open, reserved for differential sensing and current sensing. R29 is set to limit
the upper trim range based on a maximum reference voltage of 1.25 V. Note that by
default compensation components are not installed and required for operation. Default
compensation components are provided with the board as described in a later section.
SGND
SGND
VCC
R32
1206 C22
1206
EAO
R33
1206
SGND
R41
1206
+SENSE_B
-SENSE_B
LOCAL SENSE_+
2
3
1
4
8
SO8
U11A
6
5
7
U11B
1206
54.9K
R29
1206
1.27K
R31
1206
1.27K
R42
1206
1K
R36
C21
0603
IMON
R27
1206
H 48 H 47
H 51 H 52
1206
20Ω
R30
H 46 H 45
TP38 TP37
OPEN OPEN
OPEN
OPEN
OPEN
VREF
To CONTROL NODE
through S10
Preinstalled component
and connections
User installed
component
C19
1206
1206
20K
R28
1206
4.7nF
C20
H 39 H 40
H 43 H 44 H 42 H 41
To PRM +OUT
through S10
AC signal
injection
Figure 13.
Remote Sense: local sensing
(single ended) control circuitry
BLUE highlight =
Pre-installed component
GREEN highlight =
user installed component
Switch
Position ON or OFF Connection
Number
1 ON TRIM pin is shorted to GND and PRM is configured for Remote Sense
Operating mode.
2 ON CONTROL NODE pin is connected to output of external error amplifier.
3 ON IFB pin is connected to output of external current sense amplifier to set
constant current limit.
4 ON REF_EN pin is connected to input of the external voltage reference circuit
to generate voltage reference for external error amplifier.
5 ON VAUX pin is connected to power VCC of the op-amp and current sense IC.
6 OFF TM pin of the VTM is not connected to VT pin of the PRM.
7 ON PRM +OUT pin is connected to local sense (single ended) of the remote
sense control circuitry.
8 Don’t care
9 OFF See next Remote Sense Operation
10 OFF See next Remote Sense Operation
Table 6.
Switch configuration
in local sensing