Bushnell ONIX 110 - Manual (Page 43)

43
7. Use the up/down navigation keys to highlight √
and press OK.
Setting the Time
The local time can be set on the ONIX 110 using the
Time setting function. Local time is set by entering
the offset from Greenwich Mean Time. For instance, if
local time is 7 hours ahead of Greenwich Mean Time,
you will need to enter an offset of plus (+) seven
hours.
To change the Time setting:
1. Press the Menu button twice to display the main
menu.
2. Select User Settings and press OK.
3. Use the left/right navigation keys to select the
Time tab
(Fig. 81) .
4. Use the up/down navigation keys to select the
Adjust Time field.
5. Press OK to toggle between Plus and Minus.
6. Use the up/down navigation keys to highlight
the Hour field and press OK.
7. Use the up/down navigation keys to change the
Hour field and press OK to confirm your setting.
The Current Time field shows the corrected time.
8. In the Minute field, press OK to toggle between
0 and 30.
9. Use the up/down navigation keys to highlight √
and press OK to confirm the time setting.
Making a Cold Start
Use this feature to locate your position correctly,
if the ONIX 110 is unable to identify your position
after being powered on for a few minutes. This may
happen if there is old, incorrect data in the device and
the signal strength is poor due to uneven distribution
of the satellites. In some cases, you may also wish to
acquire fresh information from the satellites and clear
Fig. 81