WORX WU381 18V 2.6 Ah Lithium Ion SDS Plus Cordless Rotary Hammer Drill - Manual (Page 9)

9
Operating instructions
Note: Before using the tool, read the instruction book
carefully.
iNTENDED USE
The machine is intended for hammer drilling in concrete, brick and
stone. It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
BEFORE PUTTiNG iNTO OPERATiON
A) cHARGiNG THE BATTERY PAcK
The battery pack charger supplied is matched to the Li-Ion battery
installed in the machine. Do not use another battery charger.
The Li-Ion battery pack is protected against deep discharging. When
the battery pack is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery pack to
cool down before recharging.
When the battery pack is charged for the first time and after prolonged
storage. the battery pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOvE OR iNSTAll BATTERY PAcK (See Fig. A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be sufficient.
10
A B
C D