Rockwell Automation 20P PowerFlex DC Drive - Frame A AC CurrentTransducers for Drives w/Bus Bars - Manual (Page 14)

14 PowerFlex® DC Drive - Frame A AC Current Transducers for Drives with Bus Bars
5. While lifting the terminal bus bars out of the drive, slide the AC Current
Transducers off of the bus bars.
Step 6: Install the New AC
Current Transducers Install the new AC Current Transducers in reverse order of removal as
detailed in Step 5:
Remove the Existing AC Current Transducers above.
•
The final tightening torque for the screws connecting the bus bars to the
SCR modules is 2.5…4 N•m (22…35.4 lb•in).
Step 7: Install the Pulse
Transformer and Switching
Power Supply Boards Install the Pulse Transformer and Switching Power Supply boards in reverse
order of removal as detailed in Step 4:
Remove the Pulse Transformer and
Switching Power Supply Boards on page 8 .
Step 8: Install the Control
EMI Shield and Control
Board Install the Control EMI Shield and Control board in the reverse order of
removal as detailed in Step 3:
Remove the Control EMI Shield and Control
Board on page 6 .
ATTENTION: Each gate lead cable must be connected to the
exact connector from which it was removed on the Pulse
Transformer circuit board or damage to the drive may occur.