Rockwell Automation 20P PowerFlex DC Drive - Frame A AC CurrentTransducers for Drives w/Bus Bars - Manual (Page 5)

PowerFlex® DC Drive - Frame A AC Current Transducers for Drives with Bus Bars 5
4. Press in on the sides at the bottom edge of the top cover and at the same
time pull the cover toward you to pull it partially off the drive chassis.
5. At the top of the drive, pull the cover forward, away from the drive,
until the pins fit in the keyhole in the top of the cover, then carefully lift
the cover off of the drive chassis.
Important: The HIM assembly is connected via a cable to the
Control board and therefore will not pull free from the
drive until disconnected. See
page 5 for instructions.
Important: Mark all connections and wires before removal to avoid
incorrect wiring during reassembly.
6. Disconnect the HIM Communication cable from the connector on the
upper right corner of the Control board and set the cover aside.
When metal pin fits in keyhole,
lift cover off drive chassis.
3. 4.
Pull tabs out
to disconnect
cable.