Rockwell Automation 160 SSC Remote Keypad User Manual - Manual (Page 6)

1-2 Introduction
Remote Programming Adapter
The Remote Programming Adapter (160-RPA) allows the Remote Keypad to
interface with a Bulletin 160 Series C drive.
If your drive is equiped with a Ready/Fault Indicating Panel (160-B1) or a Program
Keypad Module (160-P1), you must remove these modules and install a Remote
Programming Adapter in order to use the Remote Keypad.
Removal and Installation
Insert a small screw driver into the slot at top of panel/keypad. Carefully pry back
and pivot the module out. Avoid bending or twisting the contact pins located
underneath the center portion of the module.
Insert the RPA module, bottom first, into the drive. Press down on the top corners
of the module until it is firmly seated.
Module Removal and Adapter Installation Figure 1.2
ATTENTION: Ensure that you disconnect line power and wait
three minutes before installing or removing the Ready/Fault
Indicating Panel or Program Keypad Module. Failure to do so could
result in personal injury or death.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference Publication 8000-4.5.2, “Guarding Against Electrostatic
Damage” or any other applicable ESD protection handbook.
DC- W/T3 V/T2 U/T1 DC+ DC- W/T3 V/T2 U/T1 DC+