Rockwell Automation 160 SSC Remote Keypad User Manual - Manual (Page 9)

Introduction 1-5
Features
The figure and table below identify and describe the Remote Keypad display, status
indicators, and keys.
Remote Keypad Features Figure 1.6
Feature Description
1 Display Four 7-segment light emitting diodes (LEDs)
2 Indicator LEDs Four LEDs indicate mode of operation.
3 Escape Key • Press to toggle between Display mode and Program mode.
• In Edit mode, press to cancel an edit sequence and return to Program
mode.
4 Enter Key • In Display or Program modes, press to toggle between parameter numbers
and values.
• In Edit mode, press to save a new parameter value.
5 Select Key In Program mode with a parameter value displayed, press to enter Edit mode.
Use the Up or Down arrow keys to change the parameter value.
6 Up and Down
Arrow Keys • In Program mode, use to scroll Program Group parameter numbers or
change a parameter value.
• In Display mode, use to scroll Display Group parameters numbers.
7 Reverse Key Changes direction of motor rotation when keypad control is selected
(P46 = 2 or 6) and reverse is enabled (P73 = 0)
8 Start Key Issues a start command to drive when keypad control is selected
(P46 = 2 or 6).
9 Stop Key • Issues a stop command to drive.
• Press to reset a fault after taking corrective action.
3
7
8
1
2
5
4
6
9
ATTENTION: The keypad
control circuitry includes solid-
state components. If hazards due
to accidental contact with
moving machinery or
unintentional flow of liquid, gas
or solids exist, an additional
hardwired stop circuit is required
to remove AC input power to the
drive. When AC input power is
removed, there will be a loss of
inherent regenerative braking
effect and the motor will coast to
a stop. An auxiliary braking
method may be required.