Rockwell Automation 161 SERIES B FRN 2.001 User Manual
User manual
Advertising
Table of contents
Document Outline
- 161 Appx_a.pdf
- New 161_bkcvr.pdf
- 161 Chptr_3.pdf
- Programming Keypad
- Programming Examples
- Initial Power Up
- Scrolling through parameter groups
- Operation of the Drive via the Fixed Keypad
- Note: The factory default settings for the “U” version drive is three wire control (PC03 is set t...
- Note: The direction of rotation is controlled by PF04 - [Start Key Direction]. Refer to page 22 o...
- Activating the Speed Pot on the Keypad
- Parameter A01-[Frequency Command Select] is used to select the source of the frequency command.
- Note: The output frequency of the Bulletin 161 can also be controlled digitally from the keypad b...
- Note: If a digital input is set as 27 (UP) or 28 (DWN), when activated these inputs will also cha...
- Restoring Factory Defaults
- Parameter Descriptions
- D Group - Display and Diagnostic Parameters (Read Only)
- F Group – Basic Function Parameters
- A Group – Advanced Function Parameters
- b Group – Advanced Control and Protection Parameters
- C Group – Intelligent I/O and Communication Parameters
- 161 Chptr_2.pdf
- Storage and Operating Conditions
- CE Compliance
- Installation
- Clearances
- Terminal Blocks
- Power Wiring
- Power Terminal Block Wiring Specifications
- Branch Circuit Protection Devices
- Input Power Conditioning
- Grounding
- Control Wiring
- Control Terminal Descriptions
- Programmable Digital Input (Control terminal block inputs 1 through 5) Functions
- 161 Chptr_3.pdf
- Programming Keypad
- Programming Examples
- Initial Power Up
- Scrolling through parameter groups
- Operation of the Drive via the Fixed Keypad
- Note: The factory default settings for the “U” version drive is three wire control (PC03 is set t...
- Note: The direction of rotation is controlled by PF04 - [Start Key Direction]. Refer to page 22 o...
- Activating the Speed Pot on the Keypad
- Parameter A01-[Frequency Command Select] is used to select the source of the frequency command.
- Note: The output frequency of the Bulletin 161 can also be controlled digitally from the keypad b...
- Note: If a digital input is set as 27 (UP) or 28 (DWN), when activated these inputs will also cha...
- Restoring Factory Defaults
- Parameter Descriptions
- D Group - Display and Diagnostic Parameters (Read Only)
- F Group – Basic Function Parameters
- A Group – Advanced Function Parameters
- b Group – Advanced Control and Protection Parameters
- C Group – Intelligent I/O and Communication Parameters
- 161 Chptr_2.pdf
- Storage and Operating Conditions
- CE Compliance
- Installation
- Clearances
- Terminal Blocks
- Power Wiring
- Power Terminal Block Wiring Specifications
- Branch Circuit Protection Devices
- Input Power Conditioning
- Grounding
- Control Wiring
- Control Terminal Descriptions
- Programmable Digital Input (Control terminal block inputs 1 through 5) Functions
- 161 Chptr_4.pdf