Lists and the data collector, Inspection codes and the data collector – Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector User Manual
Page 105
Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
105
Setting Up Measurements Chapter 3
Lists and the Data Collector
The Emonitor software and the Dynamix 2500 data collector support loading
lists of measurement definitions to the data collector.
Inspection Codes and the Data Collector
The Emonitor software and the Dynamix 2500 data collector support loading
inspection codes to the data collector. You can load inspection codes into the data
collector only with a list.
You can use only the inspection codes loaded with the list with measurements in
that list. This includes both measurements in a list and unscheduled
measurements associated with that list.
You can load up to 100 inspection codes into the data collector. The Emonitor
software numbers the inspection codes from 1-100. The data collector numbers
the inspection codes from 00-99. The data collector displays the first 16
characters of each inspection code.
Loading Inspection Codes to the Dynamix 2500 Data Collector
You can load and remove inspection codes. You must load the inspection codes
when you load a list, do this by selecting Load inspection codes in the Load
Options dialog box. If you do not select this option, no inspection codes are
available for measurements from the list or for unscheduled measurements
associated with the list.
You can remove the inspection codes from the Dynamix 2500 data collector by
initializing the data collector.