Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector - Manual (Page 118)

118 Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Chapter 4 Loading and Unloading
2. Click Load Options.
The Load/Unload dialog box appears.
3. Check the desired option under Override collect on alarm:
• Collect spectrum measurements always - Collects all spectrum
measurements, regardless of the settings in the storage specification for
the measurement definition.
• Collect time measurements always - Collects all time waveform
measurements regardless of the settings in the storage specification for
the measurement definition.
4. Click OK. Now you can collect all the spectrum and/or time waveform
measurements in the list.
Select the Lists
The Emonitor software and the Dynamix support loading more than one list at a
time, so you may select more than one list to load. The size of the lists limits the
number of lists you can load at one time.
Follow these steps to select the list.
1. Choose Tools > Load/Unload.
2. Make sure the data collector and computer are connected.
3. Make sure you have selected the desired destination (internal memory or
SD card) in the Dynamix 2500 data collector.
See Prepare the Data Collector before Loading on page 113 .
4. Select the list types to show in the list display by clicking Filter in the
Load/Unload dialog box.
IMPORTANT You must turn these load options off before loading a list if you
want to collect spectrum and/or time waveform only on alarm.