Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector - Manual (Page 141)

Rockwell Automation Publication 1441-UM001B-EN-P - September 2012 141
Collecting and Reviewing Data Chapter 5
Collect a Magnitude Measurement
Once you have created a route in the Emonitor Software and uploaded it to the
data collector you can begin to take the measurement.
See the Emonitor User Manual publication, EMONTR-UM001 for
information about creating routes and loading them into the data collector.
Follow these steps to collect a magnitude measurement.
1. Attach the DC voltage input to the data collector and correct location.
2. From the Data Collection screen, press Enter.
The Route Manager Screen Appears.
3. Select the magnitude route you uploaded from the Emonitor software and
press Enter to start your measurement for the current point.
The Magnitude Measurement screen appears.
A graphic appears on the screen while the data collector ranges the data.
The data collector continually updates the magnitude value for the
measurement.
4. Once the magnitude reading is steady and the input signal is not
overloading the data collector, press Enter to accept the measured value.
Once the data collector stores the measurement, the Data Collection screen
displays the next point in the list (route).
IMPORTANT You do not need to press Enter if you set Auto Store to
On in the Instrument Configuration screen. The data
collector automatically ranges and collects the
measurement.
See Instrument Configuration Parameters on page 59 .