Rockwell Automation 1492 Modicon 800-to-1756 I/O Swing-arm Conversion System User Manual
Page 9
(9)
10000021923
(Version 00)
II. Conversion Steps
8) Attach the Conversion Cover-plate to the Conversion Base-plate
To attach the cover-plate to the base-plate use the following procedure:
a) Refer to Figure 8a. At the top of the cover-plate are several hinge/pivot brackets. These fit into mating slots at the top of the base-plate (refer to
Figure 8b) to attach both of the components together. Locate these component mounting features before assembly.
b) With the cover-plate at about a 30-45 degree angle from the base-plate, guide the cover-plates hinge / pivot brackets into the mating slots of the
base-plate. It may be necessary to move some of the 1492 cables to mate with the cover plate legs to the base plate.
c) Slowly lower the bottom part of the cover-plate being careful to guide the lower mounting support legs so as to NOT hit and damage a conver-
sion module. Do not screw the support legs to the base-plate at this time.
Figure 8a
Figure 8c
Figure 8b
Figure 8d
Base-plate slot
Cover-plate
hinge / pivot
bracket