Rockwell Automation 1609 UPS Management Software User Manual - Manual (Page 31)

Rockwell Automation Publication 1609-UM007A-EN-P - January 2013 29
Bulletin 1609 UPS Management Software User Manual
mode, and the program will awaken the remote hosts once the actions have
been enabled.
Each Time 1609 UPS Management Startup: Program will wake up the
remote hosts which are enabled when 1609 UPS Management Software
starts and is connected to the UPS.
SNMP ATTENTION: If you are using a Windows 95/98/Me operating system, you can configure the
SNMP parameters directly from the 1609 UPS Management Software:
Select the Accept SNMP packet from any hosts, 1609 UPS Management
Software will accept all the requested commands and set commands. When you
select the Accept SNMP packet from the following hosts, 1609 UPS
Management Software receives information only from the hosts that you
assigned. Once a power event has occurred and the user enables the SNMP Trap
in the Action dialog box, 1609 UPS Management Software will send the SNMP
trap to the hosts that are listed in the Trap Target list box. To add, modify or
delete the host, click on its respective command button.
ATTENTION: If you are using a Windows 2000/XP/2003 operating system, you must install
the SNMP Service and configure the SNMP parameters from your operating system:
1609 UPS Management Software will ignore the values that were set in the
SNMP dialog box. To change the parameters of SNMP function, you should
install the SNMP Service in the Network option. Select the SNMP Service from
the Network option in the Control Panel and click the Property button to do
your changes.