Rockwell Automation 1609 UPS Management Software User Manual - Manual (Page 8)

6 Rockwell Automation Publication 1609-UM007A-EN-P - January 2013
Bulletin 1609 UPS Management Software User Manual
1609 UPS Management Software Installation
1609 UPS Management
Software Setup: 1. Turn off your computer.
2. Attach the electrical power cable from the computer to the UPS.
3. Attach the electrical power cable from the UPS to an AC power outlet.
4. Plug the communication cable into the UPS, then plug the other end of
the cable into the communication port on your computer.
5. Start your computer.
6. Place the CD in your CD-ROM device and execute the setup.exe to run
the setup program.
7. Check the communication type of your UPS. If you select the USB option
you must have connected the UPS to this computer and install the HID
driver.
8. During the installation, the following dialog gives you 3 options:
– Program File: Files contain Service, Monitor and this on-line help.
– Audio Files: Some .wav files. These files will be played to notify you
when power event occurs.
– SNMP Files, 1609 UPS Management Software SNMP DLL file.
9. After finishing the installation, setup program will create a 1609 UPS
Management Software association.
10. The 1609 UPS Management Software is comprised of two modules:
– An UPS Monitoring Module(1609 UPS Management Service), which
runs in the background as a Windows Service and communicates to the
UPS.
– An User Interface Module (1609 UPS Management Monitor), which
enables you to control and configure 1609 UPS Management Software
through the drop down menus and dialog boxes. It also allows you to
monitor the UPS through the Main Screen.
Help:1609 UPS Management Software on-line help.
Uninstall: To remove 1609 UPS Management Software from your hard disk.
1609 UPS Management Monitor: User interface, used to monitor and
configure UPS.
1609 UPS Management Status: Reflect the status of 1609 UPS Management
Software service program, the service program is used to communicate with your
UPS.