Rockwell Automation 1403-DM_LM_MM Powermonitor II Instruction Sheet - Manual (Page 39)

General Operation 4-3
1403-IN001A-US-P
Issuing a Command
1. Using the four Display Module keys, move into
Program mode and display the command to be
issued. Notice the flashing “P” in the lower right-
hand corner.
2. Set the Display Module into Edit mode by
pressing the Enter key. The “P” in the lower right-
hand corner remains solid, and the command
option prompt is flashing.
3. Choose the option of the command by pressing
the Up Arrow and Down Arrow keys until the
desired option is displayed. Notice the “P” in the
lower right hand corner remains solid, and the
command option being selected is still flashing.
4. After the desired parameter value is displayed,
press the Enter key to execute the command. The
selection prompt will reappear and the Display
Module is set back to Program mode. Notice the
“P” in the lower right-hand corner is flashing, and
the option prompt is solid.
5. In the event that a command is to be aborted,
pressing the Escape key returns the Display
Module to Program mode, and the option prompt
is displayed. Notice the “P” in the lower right-
hand corner is flashing, and the option prompt is
solid.
Force Relay 1
{ or } P
Force Relay 1
{ or } P
Force Relay 1
Energize P
Force Relay 1
{ or } P
Force Relay 1
{ or } P