Rockwell Automation 1606-XLS960FE Power Supply Reference Manual - Manual

Reference Manual
e g a P e g a P
1. Intended Use .......................................................3
2. Installation Requirements...................................3
3. AC-Input...............................................................4
4. Input Inrush Current ...........................................5
5. DC-Input...............................................................5
6. Output .................................................................6
7. Hold-up Time.......................................................8
8. DC-OK Relay Contact ..........................................9
9. Shut-down Input .................................................9
10. Remote Control of Output Voltage .................10
11. Internal Data Logging.......................................10
12. Efficiency and Power Losses..............................11
13. Lifetime Expectancy and MTBF.........................12
14. Functional Diagram...........................................12
15. Terminals and Wiring........................................13
16. Front Side and User Elements...........................14
17. EMC ....................................................................15
18. Environment ......................................................16
19. Protection Features ...........................................17
20. Safety Features ..................................................17
21. Dielectric Strength ............................................18
22. Certifications ................................................... 18
23. Physical Dimensions and Weight ..................... 19
24. Accessories ........................................................ 20
24.1. 1606-XLC Wall Mounting Bracket ............ 20
24.2. 1606-XLSBUFFER48 Module ..................... 20
25. Application Notes ............................................. 22
25.1. Repetitive Pulse Loading ..........................22
25.2. Peak Current Capability ...........................23
25.3. External Input Protection .........................23
25.4. Charging of Batteries ...............................24
25.5. Output Circuit Breakers ............................24
25.6. Parallel Use to Increase Output Power ....25
25.7. Parallel Use for Redundancy ....................25
25.8. Series Operation .......................................26
25.9. Inductive and Capacitive Loads ................26
25.10. Back-feeding Loads ..................................26
25.11. Operation on Two Phases ........................27
25.12. Use in a Tightly Sealed Enclosure ............27
25.13. Mounting Orientations ............................28
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLS960FE
Index
• PE and symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol .
• Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.
• T.b.d.—To be defined, value or description will follow later.
• AC 230V—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%)
included. E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
• 230Vac—A figure with the unit (Vac) at the end is a momentary figure without any additional tolerances included.
• 50Hz vs. 60Hz—As long as not otherwise stated, AC 230V parameters are valid at 50Hz mains frequency.
• may—A key word indicating flexibility of choice with no implied preference.
• shall—A key word indicating a mandatory requirement.
• should—A key word indicating flexibility of choice
Terminology and Abbreviations