Rockwell Automation 1403-BA Powermonitor II Lithium Battery Installation Instructions - Manual (Page 7)

Powermonitor II Lithium Battery 7
Publication 1403-IN006A-EN-P - February 2009
3. Gently pull upwards on the battery extractor tab to remove the battery from
its holder.
4. Install the lithium battery noting the correct polarity within the battery
holder.
Note that the battery must be installed over top of the battery extractor flap.
The lithium battery should be held securely in place within the battery
holder.
5. Refold the battery extractor over top of the lithium battery and insert the
retaining tab back into the slot.
ATTENTION
The battery is held under pressure within its holder and may be forcefully ejected upon
extraction.