Rockwell Automation 1394-SR10A External Shunt Resistor Kit - Manual (Page 5)

1394 External Shunt Resistor Kit 5
Publication 1394-5.6 — December 1999
Wiring Your External Shunt Resistor (Series C)
1. Locate and unplug the J11 connector on the bottom of the system
module.
2. Remove and discard the jumper wire between J11-1 and J11-2, as
shown in Figure 4.
Figure 4
1394 System Module Jumper Removal (Series C)
3. Install the shunt resistor wire leading to the fuse in connector
J11-1.
4. Install the other shunt resistor wire in connector J11-3.
5. Tighten the J11 connector screws (torque value = 0.56-0.62 N-m,
5.0-5.6 lb-in.).
6. Re-apply power and resume operation. Refer to the 1394 Digital,
AC, Multi-Axis Motion Control System User Manual (publication
1394-5.0) for startup information.
Important: Use fuse replacement kit (1394-SR10A-FUSE-A) when
replacing the 1394-SR10A shunt fuse. Refer to the 1394
Digital, AC, Multi-Axis Motion Control System User
Manual (publication 1394-5.0) for additional
information regarding fuse replacement kits.
1 2 3
J11
1394 bottom view
Remove jumper