Rockwell Automation 1394-DCLM DC Link Module User Manual
Page 3
Publication 1394-5.11 December 1999
Installing Your 1394 DC Link Module
3
4. Slide the slide-and-lock mechanism on the 1394-DCLM to the
left until it locks into the module on its left.
Figure 3
Sliding the Slide-and-lock Mechanism into Position
5. Attach the terminator to the 1394-DCLM and slide it to the left
until it locks into place.
Figure 4
Attaching the Terminator to the 1394-DCLM
6. Install the lower fastener.
7. Tighten the upper and lower fasteners
Important: If you are using the 1394-DCLM for additional
capacitance (stand-alone), leave the power plug
(catalog number 1394-CPDCP) attached to the front
underside of the module and apply power to your
system.
Slide-and-lock
mechanism
DC Link
Module
1394 Digital Servo Controller
System Module
Allen-Bradley
Attaching the
Terminator
DC Link
Module
1394 Digital Servo Controller
System Module
Allen-Bradley