Rockwell Automation 1791-IOBB USER MANUAL - Manual (Page 27)

Chapter
5
5Ć1
Configuring Your Block I/O for SLC
Controllers
In this chapter you will learn to identify block I/O switches and their
position.
Refer to publication 1747–ND012, Distributed I/O Scanner and Block, for
complete information on switch settings and addressing of the block I/O.
Each block I/O module has two 6–position DIP switches for setting:
block address
transmission (baud) rate
last state or reset
DH–485 termination
These switches are accessible by opening the door on the left side of the
module (Figure 5.1).
Chapter Objectives
Setting the Configuration
Switches