Rockwell Automation 1757-SWKIT5000 Getting Started with ProcessLogix R500.1 Quick Start - Manual (Page 15)

Getting Started with ProcessLogix R500.1 15
Publication 1757-QS500A-EN-P - October 2002
Assigning Modules to a CEE
Once you have configured I/O modules, you must assign them to the CEE. To assign
modules to the CEE:
1. From Control Builder, select Tools⇒Assign.
You see the Execution Environments Assignment window:
2. Click the IOMs tab in the Available Modules area.
3. To select all four modules, click the first module, hold down the Shift Key, and click
the last module.
4. Select CEE0101 from the Assign To: box.
5. Click Assign.
After a few seconds, the IOMs are displayed in the Assigned Modules list box. This
indicates that the I/O modules you just assigned are being used by the selected
CPM/CEE, and cannot be assigned to other CPMs.
6. After the modules are assigned, click close.