Rockwell Automation 1756-CN2_CN2R, Series B ControlLogix ControlNet Interface Module - Manual (Page 13)

ControlLogix ControlNet Interface Module 13
Publication 1756-IN607A-EN-P - February 2008
Install the Module
To install the module, perform this procedure.
1. Align the circuit board with top and bottom guides in the
chassis.
2. Slide the module into the chassis.
Make sure the module backplane connector properly connects
to the chassis backplane.
Do not force the module into the backplane connector. If you cannot
seat the module with firm pressure, check the alignment. Forcing the
module into the chassis can damage the backplane connector or the
module.
The module is properly installed when it is flush with the power
supply or other installed modules.
ATTENTION
1
2
Circuit
Board