Rockwell Automation 1734-OV2E_4E_8E POINT I/O Protected Sink Output Module Installation Instructions - Manual (Page 14)

14 POINT I/O Protected Sink Output Module
Publication 1734-IN585C-EN-E - December 2005
Wire the Module
Refer to the figures to wire the module.
WARNING
If you connect or disconnect wiring while the field-side
power is on, an electrical arc can occur. This could cause
an explosion in hazardous location installations. Be sure
that power is removed or the area is nonhazardous before
proceeding.
IMPORTANT
To comply with the CE Low Voltage Directive (LVD), I/O
must be powered from a source compliant with the
following: Safety Extra Low Voltage (SELV) or Protected
Extra Low Voltage (PELV).
Module Status
Network Status
Status of Output 0
Status of Output 1
Status of Output 2
Output 1
1734-OV2E 1734-OV4E
C = Common
V = Supply
42029 42028
24VDC
Sink
Output
Module
Status
Network
Status
1734
OV8E
NODE:
0
1
2
3
4
5
6
7
1734-OV8E
42030
Status of Output 0 & 4
Status of Output 1 & 5
Status of Output 2 & 6
Status of Output 3 & 7
Output 3
Output 5
Output 7
Output 1
N/C
C
V
Output 0
Output 2
Output 4
Output 6
Output 1
Output 3
V
V
Output 0
Output 2
V
V
Output 0
N/C
C
V
Status of Output 3
24VDC
Sink
Output
Module
Status
Network
Status
1734
OV4E
NODE:
0
1
2
3
2
24VDC
Sink
Output
Module
Status
Network
Status
1734
OV2E
NODE:
0
1