Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Encoder Module Installation Instructions - Manual (Page 9)

POINT I/O Synchronous Serial Interface Absolute Encoder Module 9
Publication 1734-IN581D-EN-E - January 2014
Install the Module
The module can be installed before or after base installation. Make sure that the mounting
base is correctly keyed before installing the module into the mounting base. In addition,
make sure the mounting base locking screw is positioned horizontal referenced to the base.
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base clockwise
until the number required for the type of module being installed aligns with the
notch in the base.
2. Make certain the DIN rail locking screw is in the horizontal position. You cannot
insert the module if the locking mechanism is unlocked.
3. Insert the module straight down into the mounting base.
4. Press to secure. The module locks into place.
Turn the keyswitch to align the number
with the notch. Position 3 is shown here.
44009
Be sure the DIN rail locking screw
is in the horizontal position.
44010
24VDC Source Output
Module Status Network Status
1734 OB4E
NO DE :
0
1 2
3
44012