Bakers Pride DRG-40 - Manual (Page 15)

Gas Rotisserie Oven Operation
13
Probe (Thermocouple) Diagnostics
If the probe (thermocouple inside the oven) stops working, the controller will cancel the cooking cycle, an audible
alert will sound, and the display will show “PROB”.
Operation After Gas or Power Outage
The oven will shut off automatically if the gas supply is interrupted or the power goes out. If either of these
conditions occur you should perform the following procedure:
For your safety, if the gas supply stops, or, if the power goes out, make sure to wait for at
least five minutes before restarting your oven. This allows time for any unburned gas to
dissipate. (LP gas may take longer than five minutes.) If you smell gas, do not start your
oven.
1. Place the POWER switch, HEAT switch, LOWER FLAME switch, LIGHTS switch, and ROTOR switch
located on the front panel in the “OFF” position.
2. Wait at least five minutes to allow any gas that may have accumulated in the burner compartment to
escape.
3. Follow normal operating procedures once the power or gas is restored.
Normal Shutoff
1. Place the HEAT switch, LOWER FLAME switch, and LIGHTS switch in the “OFF” position.
2. Wait at least five minutes to allow oven to cool.
3. Place the POWER switch and ROTOR switch in the “OFF” position.