Bakers Pride DRG-40 - Manual (Page 33)

VR8105, VR8205, AND VR8305 DIRECT IGNITION COMBINATION GAS CONTROLS
69-1226—2 6
Fig. 5. Proper use of wrench on gas control with and without flanges.
Fig. 6. Top view of gas control.
Wiring
Follow the wiring instructions furnished by the appliance
manufacturer, if available, or use the general instructions
provided below. When these instructions differ from the
appliance manufacturer, follow the appliance
manufacturer instructions.
All wiring must comply with applicable electrical codes
and ordinances.
Disconnect power supply before making wiring
connections to prevent electrical shock or equipment
damage.
1. Check the power supply rating on the gas control
and make sure it matches the available supply.
Install a transformer and other controls as required.
2. Connect the control circuit to the gas control
terminals. See Fig. 7 and 8.
3. Adjust thermostat heat anticipator to 0.50A rating
stamped on valve operator.
APPLY WRENCH
FROM TOP OR
BOTTOM OF GAS
CONTROL TO
EITHER SHADED AREA
WHEN FLANGE IS NOT USED
APPLY WRENCH
TO FLANGE ONLY
WHEN FLANGE IS USED
M3084A
HI-LO
ADJUSTMENT SCREWS
(UNDER CAP)
REGULATOR
VENT COVER
INLET
INLET
OUTLET
M10967A
HI
LO
OUTLET
PRESSURE
TAP
WIRING
TERMINALS (2)
INLET
PRESSURE TAP
PRESSURE REGULATOR
ADJUSTMENT (UNDER
CAP SCREW)
GAS CONTROL KNOB
TWO-STAGE
PRESSURE
REGULATOR
MODEL
69-1226-2.fm Page 6 Thursday, November 13, 2003 12:50 PM