Rockwell Automation 1732D-XXXX DeviceNet ArmorBlock I/O, Series A - Manual (Page 8)

Publication 1732D-IN001B-EN-E - May 2004
8 DeviceNet 1732 ArmorBlock I/O, Series A
Refer to the illustration below for configuration operations.
Please refer to publication 889-CG001 for Rockwell Automation cables
and cord sets offerings or access the Connection Systems website at:
http://www.ab.com/sensors/products/connection_systems/index.html
F or M12 (micro) style connections, please reference the 889D
products. For M8 (pico) style connections, please reference the 889P
products
.
IMPORTANT
If the devices (sensors) connected to the input
connections require Class 2 power to operate, the
auxiliary power connections of this equipment must
be powered by a Class 2 source.
ATTENTION
Make sure all connectors and caps are securely
tightened to properly seal the connections against
leaks and maintain IP67 requirements.
MSD LSD
DeviceNet
Node Address
4-12mm or 8-8mm I/O
Connectors
Status LED
Sensor and
Actuator Power
All I/O are 24V dc sink in/source out
- 8 input
- 8 output
- 8 input or output points
- any mix of 8 (e.g., 7 + 1; 3 + 5)
Output short circuit protected
Output monitoring in “self-configuring” style
43602